Netgear FWG114Pv2 FWG114Pv2 Reference Manual - Page 123
Table 8-1., VPN Manual Policy Configuration Fields
View all Netgear FWG114Pv2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P v2 The VPN Manual Policy fields are defined in the following table. Table 8-1. VPN Manual Policy Configuration Fields Field Description General These settings identify this policy and determine its major characteristics. Policy Name The name of the VPN policy. Each policy should have a unique policy name. This name is not supplied to the remote VPN Endpoint. It is used to help you identify VPN policies. Remote VPN Endpoint The WAN Internet IP address of the remote VPN firewall or client to which you wish to connect. The remote VPN endpoint must have this FWG114P v2's WAN Internet IP address entered as its "Remote VPN Endpoint." Traffic Selector These settings determine if and when a VPN tunnel will be established. If network traffic meets all criteria, then a VPN tunnel will be created. Local IP The drop down menu allows you to configure the source IP address of the outbound network traffic for which this VPN policy will provide security. Usually, this address will be from your network address space. The choices are: • ANY for all valid IP addresses in the Internet address space Note: Selecting ANY means all traffic goes through the IPSec tunnel and prevents access to the Internet. • Single IP Address • Range of IP Addresses • Subnet Address Remote IP The drop down menu allows you to configure the destination IP address of the outbound network traffic for which this VPN policy will provide security. Usually, this address will be from the remote site's corporate network address space. The choices are: • ANY for all valid IP addresses in the Internet address space Note: Selecting ANY means all traffic goes through the IPSec tunnel and prevents access to the Internet. • Single IP Address • Range of IP Addresses • Subnet Address Authenticating Header (AH) Configuration AH specifies the authentication protocol for the VPN header. These settings must match the remote VPN endpoint. Note: The "Incoming" settings here must match the "Outgoing" settings on the remote VPN endpoint, and the "Outgoing" settings here must match the "Incoming" settings on the remote VPN endpoint. Virtual Private Networking 201-10301-02, May 2005 8-11