Netgear FWG114Pv2 FWG114Pv2 Reference Manual - Page 186

Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P v2 LEDs Never Turn Off When the router is turned on, the LEDs turns on for about 10 seconds and then turns off. If all the LEDs stay on, there is a fault within the router. If all LEDs are still on one minute after power up: • Cycle the power to see if the router recovers. • Clear the router's configuration to the factory defaults. This will set the router's IP address to 192.168.0.1. This procedure is explained in "Restoring the Default Configuration and Password" on page 11-7. If the error persists, you might have a hardware problem and should contact technical support. LAN or Internet Port LEDs Not On If either the LAN LEDs or the Internet LED do not light when the Ethernet connection is made, check the following: • Make sure that the Ethernet cable connections are secure at the router and at the hub or workstation. • Make sure that power is turned on to the connected hub or workstation. • Be sure you are using the correct cable: When connecting the router's Internet port to a broadband modem, use the cable that was supplied with the broadband modem. This cable could be a standard straight-through Ethernet cable or an Ethernet crossover cable. 11-2 201-10301-02, May 2005 Troubleshooting