Netgear GSM7324 FSM7326P User Manual - Page 82

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software Dot1P Commands classofservice dot1pmapping This command maps an 802.1p priority to an internal traffic class for a device when in 'Global Config' mode. The number of available traffic classes may vary with the platform. Userpriority and trafficclass can both be the range from 1-7. Under 'Interface Config' mode, this command maps an 802.1p priority to an internal traffic class for a specific interface. The command (in either modes) is only available on platforms that support priority to traffic class mapping on a 'per-port' basis, and the number of available traffic classes may vary with the platform. Format Mode classofservice dot1pmapping Global Config or Interface Config show classofservice dot1pmapping This command displays the current 802.1p priority mapping to internal traffic classes for a specific interface. The slot/port parameter is required on platforms that support priority to traffic class mapping on a 'per-port' basis. Platforms that support priority to traffic class mapping on a per-port basis: Format show classofservice dot1pmapping Platforms that do not support priority to traffic class mapping on a per-port basis: Format show classofservice dot1pmapping Mode Privileged EXEC and User EXEC vlan port priority all This command configures the port priority assigned for untagged packets for all ports presently plugged into the device. The range for the priority is 0-7. Any subsequent per port configuration will override this configuration setting. Format vlan port priority all Mode Global Config 8-16 202-10009-01_060204 Switching Commands