Netgear GSM7324 FSM7326P User Manual - Page 93

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software Format show snmpcommunity Mode Privileged EXEC SNMP Community Name The community string to which this entry grants access. A valid entry is a case-sensitive alphanumeric string of up to 16 characters. Each row of this table must contain a unique community name. Client IP Address - An IP address (or portion thereof) from which this device will accept SNMP packets with the associated community. The requesting entity's IP address is ANDed with the Subnet Mask before being compared to the IP Address. Note: That if the Subnet Mask is set to 0.0.0.0, an IP Address of 0.0.0.0 matches all IP addresses. The default value is 0.0.0.0 Client IP Mask - A mask to be ANDed with the requesting entity's IP address before comparison with IP Address. If the result matches with IP Address then the address is an authenticated IP address. For example, if the IP Address = 9.47.128.0 and the corresponding Subnet Mask = 255.255.255.0 a range of incoming IP addresses would match, i.e. the incoming IP Address could equal 9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0 Access Mode The access level for this community string. Status The status of this community access entry. show snmptrap This command displays SNMP trap receivers. Trap messages are sent across a network to an SNMP Network Manager. These messages alert the manager to events occurring within the switch or on the network. Six trap receivers are simultaneously supported. Format show snmptrap Mode Privileged EXEC SNMP Trap Name IP Address The community string of the SNMP trap packet sent to the trap manager. This may be up to 16 alphanumeric characters. This string is case sensitive. The IP address to receive SNMP traps from this device. Enter 4 numbers between 0 and 255 separated by periods. Switching Commands 202-10009-01_060204 8-27