Netgear GSM7324 FSM7326P User Manual - Page 92
show serviceport, show snmpcommunity, ServPort Configuration Protocol Current
UPC - 606449029062
View all Netgear GSM7324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software Character Size Flow Control Stop Bits Parity Type 38400,57600, and 115200 baud. The factory Default is 9600 baud. The number of bits in a character. The number of bits is always 8. Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Control is always disabled. The number of Stop bits per character. The number of Stop bits is always 1. The Parity Method used on the Serial Port. The Parity Method is always None. show serviceport This command displays service port configuration information. Format Mode show serviceport Privileged EXEC IP Address The IP address of the interface. The factory default value is 0.0.0.0 Subnet Mask Default Gateway The IP subnet mask for this interface. The factory default value is 0.0.0.0 The default gateway for this IP interface. The factory default value is 0.0.0.0 ServPort Configuration Protocol Current Indicates what network protocol was used on the last, or current power-up cycle, if any. Burned in MAC Address The burned in MAC address used for in-band connectivity. show snmpcommunity This command displays SNMP community information. Six communities are supported. You can add, change, or delete communities. The switch does not have to be reset for changes to take effect. The SNMP agent of the switch complies with SNMP Version 1 (for more about the SNMP specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community parameters). 8-26 202-10009-01_060204 Switching Commands