Nokia IP380 Installation Guide - Page 36
Using a Console Connection to Perform the Initial Configuration - console settings
View all Nokia IP380 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
3 Performing the Initial Configuration Using a Console Connection to Perform the Initial Configuration If you do not use DHCP to perform the initial configuration of your IP300 Series appliance, you must use a serial console connection (cable included). After you perform the initial configuration, the console connection is no longer required. You can use any standard VT100-compatible terminal with an RS-232 data terminal equipment (DTE) interface or terminal-emulation program configured with the following settings for the console: 9600 bps 8 data bits No parity 1 stop bit To connect to the console 1. Connect the supplied null-modem cable (console cable) to the console port on the front panel of the IP300 Series appliance. Use only the DB9 port on the front panel labeled Console; the serial (AUX) port is an auxiliary modem port. If you connect the console port to a data communications equipment (DCE) device, use a straight-through cable. Console port For cable pin assignments for the console connection, see "Built-in Console Port" on page 15. 28 Nokia IP300 Series Security Platform Installation Guide