NordicTrack 14.0 Elliptical Uk Manual - Page 7
Tip: Avoid pinching the Sensor Wire Harness
View all NordicTrack 14.0 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Set the Rear Stabilizer (5) on the floor behind the Frame (1). Locate the wire tie in the Rear Stabilizer. See the inset drawing. Tie the end of the wire tie to the Sensor Wire Harness (155). Pull the other end of the wire tie until the Sensor Wire Harness (155) is routed through the Rear Stabilizer (5). 3 5 Wire Tie 1 155 Wire Tie 155 Wire Tie 4. Tip: Avoid pinching the Sensor Wire Harness (155). 4 Avoid pinching Set a sturdy piece of packing material under the rear of the Frame (1). Have a second person the Sensor Wire Harness (155) hold the Frame to prevent it from tipping while you complete this step. 72 Insert the Rear Stabilizer (5) into the Frame (1). Attach the Rear Stabilizer with four M8 x 16mm Screws (72); start all four Screws, and then tighten them. Remove the packing material. 155 5 72 1 5. Untie and discard the wire tie (not shown) on the Sensor Wire Harness (155). While a second person holds the Rear Stabilizer Cover (2) near the Rear Stabilizer (5), connect the wire on the Ultrasonic Sensor (147) to the Sensor Wire Harness (155). Insert the excess wire into the Rear Stabilizer. Tip: Avoid pinching the Sensor Wire Harness (155). Press the four Mounts (117) on the underside of the Rear Stabilizer Cover (2) into the Rear Stabilizer (5). 5 Avoid pinching the Sensor Wire Harness (155) 2 117 147 155 5 7