NordicTrack S10 I Studio Bike Instruction Manual - Page 10
the wires C
View all NordicTrack S10 I Studio Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
5. Insert the Handlebar (97) into the Handlebar Post (7). Attach the Handlebar with four 5 M8 x 12mm Screws (93); start all the Screws, and then tighten them. 97 93 7 93 6. Tip: Avoid pinching the wires (C). Slide the Console Support (8) onto the Handlebar (97). 6 Attach the Console Support (8) with an M10 x 52mm Bolt (94) and an M10 Jam Nut (95); make sure that the Jam Nut is in the hexagonal hole (D). Do not fully tighten the Bolt yet. Avoid pinching the wires (C) 8 94 D 97 95 C 10
10
5
6.
Tip: Avoid pinching the wires (C).
Slide the
Console Support (8) onto the Handlebar (97).
Attach the Console Support (8) with an
M10 x 52mm Bolt (94) and an M10 Jam Nut
(95);
make sure that the Jam Nut is in the
hexagonal hole (D). Do not fully tighten the
Bolt yet.
Avoid pinching
the wires (C)
6
D
C
94
8
97
95
5.
Insert the Handlebar (97) into the Handlebar
Post (7). Attach the Handlebar with four
M8 x 12mm Screws (93);
start all the Screws,
and then tighten them.
97
7
93
93