NordicTrack S10 I Studio Bike Instruction Manual - Page 11

7. Look under the Console Support (8) and identify the Upper Wire (123), which has a larger connector than the Extension Wire (124). Connect the Upper Wire (123) to the Lower Wire (122) extending from the Handlebar Post (7). Then, insert the connectors on both Wires into the Handlebar Post. Next, connect the Extension Wire (124) to the Control Wire (125) extending from the Handlebar (97). Then, insert the connectors on both Wires into the Handlebar. 7 8 123 122 97 125 124 7 8. Have a second person hold the Console (10) near the Console Bracket (11). Plug the Upper Wire (123) and the Extension Wire (124) into the receptacles on the back of the Console (10); make sure to plug the Wire marked with red into the receptacle marked with red, and plug the Wire marked with yellow into the receptacle marked with yellow. Tip: Avoid pinching the wires. If necessary, tilt the Console Bracket (11) upward to make this step easier. Attach the Console (10) to the Console Bracket with four M4 x 16mm Screws (83); start all the Screws, and then tighten them. 8 10 11 123 83 83 124 Avoid pinching the wires 11