NordicTrack S10 I Studio Bike Instruction Manual - Page 9
do not, fully tighten the Screws yet., See the inset drawing., Then, fully tighten all six M10 x
View all NordicTrack S10 I Studio Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
3. Attach the Rear Stabilizer (4) to the Base (2) with four M10 x 20mm Screws (105); do not fully tighten the Screws yet. See the inset drawing. Finish attaching the Rear Stabilizer (4) with two additional M10 x 20mm Screws (105). Then, fully tighten all six M10 x 20mm Screws (105). 3 105 105 2 4 105 105 4 4. See the inset drawing. Orient the Handlebar Post (7) so that the lower slot (A) is on the side 4 shown. Next, loosen the indicated Post Knob (100) and insert the Handlebar Post (7) into the Frame (1) until the lower end of the Handlebar Post is below the Frame. Then, tighten the Post Knob. Then, insert the end of the Lower Wire (122) into the Frame (1) and the Handlebar Post (7) and pull it out of the upper slot (B) in the Handlebar Post as shown by the dashed line at the right. 7 B 7 100 1 122 A 100 1 9