NordicTrack S10 I Studio Bike Instruction Manual - Page 32
HOW TO ADJUST THE DRIVE BELT, first unplug the power cord., one half turn.
View all NordicTrack S10 I Studio Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
HOW TO ADJUST THE DRIVE BELT If you feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest setting, the drive belt may need to be adjusted. To adjust the drive belt, first unplug the power cord. Then, follow the instructions below. Note: The drawings show only the right side of the studio cycle. Remove the indicated M4 x 16mm Screw (83) and the Shield Cover (31) from each side of the studio cycle. Next, loosen the M10 Axle Nut (27) on each side of the studio cycle, and tighten the Adjustment Nut (26) on each side of the studio cycle one half turn. Then, firmly retighten the M10 Axle Nuts. Plug in the power cord and pedal the studio cycle to test the adjustment. If necessary, repeat the above actions until the pedals no longer slip. When the drive belt is properly adjusted, reattach the shield covers. 31 83 27 26 32