NordicTrack X7i Treadmill English Manual - Page 11
If You Do Not Connect The Con
View all NordicTrack X7i Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
5. See the inset drawing. Connect the Base Wire (52) to the Upright Wire (75). The connectors 5 should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON- NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Then, remove the tie (A) from the Base Wire (52), and insert the connectors into the hole (B) in the right Upright (83). 83 B A 75 52 75 52 6. Identify the right handrail assembly (C). Hold the right handrail assembly near the right side of 6 the console assembly (D), and connect the two pulse wires (E). Next, set the right handrail assembly (C) on the console assembly (D). Make sure that no wires are pinched. Attach the right handrail assembly (C) with two 3/8" x 5 1/2" Screws (1); start both Screws, and then tighten them. Attach the left handrail assembly (not shown) as described above. C E D 1 1 11