Oki C3530nMFP Network User's Guide - Page 18

without a DHCP server, you must assign the IP address manually. For instructions on how to do this, see "Manually configuring the IP address" on page 18. Now that both Windows and the printer have been configured to use TCP/IP, the next step is to configure Windows to print to the network printer. STARTING THE NETWORK CARD SETUP UTILITY Once installed, you can launch the Network Card Setup utility by selecting Start -> Programs -> Okidata -> Network Card Setup. MANUALLY CONFIGURING THE IP ADDRESS If there is no DHCP protocol to automatically assign IP addresses to devices on your network, you might want to set the IP Address, Subnet Mask and Default Gateway Address for your printer manually. 1. In the "Network Card Setup" pane, click to select the printer. 2. Click the Setting Printer icon. The Setting Printer dialog appears. 3. Select "Manual". In the Details section, you can now edit the IP Address, Subnet Mask and Default Gateway Address. 4. Click OK. The "Admin Password Required" dialog appears. 5. Enter the password. The default password is the last 6 digits of the MAC Address (upper case). 6. Click OK. Allow a few seconds for the changes to save and the printer to automatically restart before the "Setup Completed" message box appears. NOTE: If your printer stops at any time, you can restart it by selecting Printer -> Restart Printer in the "Network Card Setup pane". CHANGING THE ADMIN PASSWORD To change the Admin Password for your printer: 1. Select Settings -> Change Password. 2. Enter the new password as requested. 3. Click OK. Allow a few seconds as the settings are saved and the printer automatically restarts. Network User's Guide for C3400n and C3530 MFP Windows - 18