Oki C9600n C9600 Network and Configuration Guide - Page 182
Configuring the Print Server
View all Oki C9600n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
Printing from UNIX: Configuring the Print Server The first step in installing the network card under UNIX is to set up the IP address, Subnet Mask and Gateway. This section explains one way to set them up from a UNIX workstation. • The network addresses used in this manual are shown as examples only. Network addresses used in your installation must be generated for your own network. • Log in as [root] to change the configuration of the Print Server. By default, there is no root password. Important! If an incorrect IP address, Subnet Mask or Gateway is entered, the network may go down or other damage may occur. Check the address with your network manager. The following explanation uses Sun Solaris 2.8 (Solaris 8) as an example. The actual commands may differ between versions of UNIX, so refer to the workstation manuals for more information. 1. Log in as root to the workstation. If you do not have superuser rights, the network manger should conduct the configuration. 2. If the print server does not have an IP addresses already assigned, use the arp command to set a temporary IP address. Example For IP address 172.68.20.127 and network card address 00:80:92:01:00:D2: # arp -s 172.168.20.127 00:80:92:01:00:D2 temp Printing from UNIX: Configuring the Print Server • 182