Oki C9600n C9600 Network and Configuration Guide - Page 251
Power Setup
View all Oki C9600n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 251 highlights
Item Enable HDD Value No Yes Enable No Initialization Yes Power Setup Item Peak Power Control Value Normal Low Power Save Enable Disable Description Even if a machine is inoperable at installation because an HDD has been damaged, you can make the machine operable by setting to NO to signify that no HDD is attached, regardless of the existence of an HDD. While NO is set, access to an HDD results in FAIL because the HDD is regarded as not attached even if the HDD is operating normally. Prevents a setup change accompanying initialization of Block Device (HDD, FLASH). Description The fuser of the printer has two lamps. When the lamps turn on, the printer's power draw increases dramatically. Normal: Both lamps light at the same time. When this happens, the printer's power draw increases dramatically. Low: The lamps do NOT light at the same time. The printer's electrical draw increases, but not as dramatically. Enables/Disables the power save mode. 251