Olympus 8080 C-8080 Wide Zoom Reference Manual (English) - Page 92
Changing the time until remote control is activated, Press, while holding down
UPC - 050332146105
View all Olympus 8080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Remote control shooting TIPS The self-timer/remote control lamp does not blink after pressing the shutter button on the remote control device. → The remote control device may be too far from the camera. Move closer to the camera and press the shutter button on the remote control device again. → The battery in the remote control device is running low. Replace with a new battery. g"How to replace the battery (CR2025) of the remote control device" (P.220) How to cancel the remote control mode. → The remote control mode is not canceled automatically after shooting. Perform Step 2 and set the mode to OFF. • If the remote control receiver is exposed to strong light, the effective signal distance may be reduced or shooting may not take place. Note • To shoot sequential shots using the remote control device, press and hold the shutter button on the remote control device. If the camera does not 5 receive the remote control signal properly, sequential shooting may stop. Changing the time until remote control is activated You can select the time from when the shutter button on the remote control device is pressed until the picture is taken. AUTO 3 SEC The picture is taken immediately the shutter button on the remote control device is pressed. The picture is taken approximately 3 seconds after the shutter button on the remote control device is pressed. 1 Press e while holding down B. B Self-timer/Remote control • In Y mode, the menu is not displayed when e is button pressed. Advanced shooting 2 Press ac to select AUTO or 3 SEC, then press e. Arrow pad OK button AUtO 3 SEC SELECt GO 91