Panasonic CF-27LBAGHEM Operating Instructions - Page 23
Dealing With Problems
View all Panasonic CF-27LBAGHEM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Dealing With Problems When a problem occurs, refer to this page. The Reference Manual also contains detailed information. If you still cannot troubleshoot the problem, contact Panasonic Technical Support. Starting Up The power indicator or battery indicator is not lit Check the cable connection for the AC adapter. Check to see if a fully charged battery is properly installed. Remove the battery pack and disconnect the AC adapter, then connect them again. is displayed Please input your password. If you have forgotten it, contact Panasonic Technical Support. [POST Startup Error(s)] is displayed page 21 Windows startup, or an operation is extremely slow Press F9 in the Setup Utility ( "Setup Utility"). This will restore the Setup Utility's settings to their default values (except the password settings). Then, the Setup Utility must be run once again for you to input the appropriate operating environment settings. (The processing speed depends on the application software used, so this operation may not cause the processing speed to increase.) An operation is slow Have you deleted the check mark for "Allow Windows to manage power use on this computer" in [Start] - [Settings] - [Control Panel] - [Power] ? If it is unmarked, the computer may automatically enter a power saving mode to prevent the temperature from rising above allowable levels, depending on usage condition. Add the check mark to "Allow Windows to manage power use on this computer". The date and time are incorrect You can set the date and time through [Date/Time] in [Start] - [Settings] - [Control Panel]. If you continue to experience problems, the internal battery maintaining the clock may need to be replaced. Please contact Panasonic Technical Support. Windows NT When [APM 2.0 for NT] is not displayed in [Control Panel], this indicates that Phoenix APM 2.0 for Windows NT® is not installed. When the suspend or hibernation function is used under this condition, the date and time may be incorrectly displayed. Correct the date and time, and then install Phoenix APM 2.0 for Windows NT®. You can set the date and time through [Date/Time] in [Start] - [Settings] - [Control Panel]. Others Press F9 in the Setup Utility ( "Setup Utility"). This will restore the Setup Utility's settings to their default values (except the password settings). Try removing all peripheral devices. Windows 95 In the MS-DOS mode, run SCANDISK to check the hard disk. At start-up, press F8 to operate the computer in the Safe mode. Shutting down Windows 95 Unable to shut down Windows 95 If a USB device is connected, try removing it. Do not shut down Windows during music playback. Battery Indicator The red indicator lights. Repeated beeping sound while the computer is in use. The red indicator blinks After the AC adapter is connected, the orange indicator blinks five times The battery level is low. Save your data and power off your computer. After connecting the AC adapter or replacing the battery pack with a fully charged one, turn your computer on. The battery pack or recharging function may be defective. Quickly remove the battery pack and disconnect the AC adapter, then connect them again. If the problem persists, contact Panasonic Technical Support. Unable to charge because of an improper temperature range. ( page 6) 23 Troubleshooting