Panasonic P2 Handheld Camcorder Advance Operating Instructions - Page 109
Nonlinear editing with P2 card (PC mode: USB device)
View all Panasonic P2 Handheld Camcorder manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Editing Nonlinear editing with P2 card (PC mode: USB device) A USB 2.0 connection to a computer or other device allows you to use P2 cards in the camerarecorder as mass storage. Procedures for making connections to a personal computer 4 Turn the POWER/MODE switch to the MODE position to illuminate the PB/THUMBNAIL lamp, and then turn and hold it. 1 Connect a USB cable to the USB 2.0 connector. A USB 2.0 cable is not supplied with the AG-HPX250P/EN. Use a commercially available USB cable (with shielding or other noise-reduction measures) that supports USB 2.0. (Page 102) USB 2.0 Connector (DEVICE) • The PC lamp illuminates, the camera enters PC mode, and video/audio output stops. • You cannot switch to PC mode directly from CAMERA mode. Leaves the thumbnail screen of PB/THUMBNAIL mode. To make a USB connection, you must first install the P2 software on the supplied CD-ROM on the computer. Select the "AG-HPX250" driver. This USB driver supports only the Windows operating system. For details, refer to the installation manual. 2 Select USB DEVICE in PC MODE SELECT on the setting menu SYSTEM SETUP screen, and press SET on the Operation lever. • Refer to the section "Basic operations of setup menus" (Page 28 of Vol. 1) for menu operation. SYSTEM SETUP SYSTEM MODE 1080-59.9i REC SIGNAL CAMERA REC FORMAT DVCPROHD/60i CAMERA MODE 24PA SCAN REVERSE OFF ASPECT CONV LETTER BOX SETUP 7.5%A PC MODE SELECT USB DEVICE PUSH MENU TO RETURN • A USB driver must be installed on the computer. • Use a computer that supports USB 2.0 since the camera-recorder supports only USB 2.0. • Connect only one camera-recorder to a personal computer via USB. • Do not remove P2 cards when the camerarecorder is connect to a personal computer via USB. • In a USB connection, the P2 card access lamp is on only when the card is accessed. • In USB device operation, recording, playback and clip thumbnail operations are not available. • The free space and status of P2 cards is not displayed when operating as a USB device, and video/audio cannot be output or displayed. 3 Press MENU twice to exit the menus. (Continued on the next page) 109