Panasonic PVDV401D PVDV201 User Guide - Page 27

Playback You Recordings

Get Panasonic PVDV401D - DIGITAL VIDEO CAMCOR PDF manuals and user guides View all Panasonic PVDV401D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

Playback your Recordings BBaassiicc OOppeerraattiioonn Playback using the LCD Monitor You can also use the LCD monitor to playback your recording. VOLUME KEY Before you begin • Connect the Palmcorder to a power source. (See pages 11, 12.) • Insert a recorded cassette. • Set POWER to VCR. 1LCD-OPEN Button 2REWIND 4 3 STOP SEARCH Button Button PLAY Button 180° 90° 90° Built-in Speaker You can place the Palmcorder on a table, etc. for viewing. Rotate the LCD Monitor 180° and swing it up against the Palmcorder body as shown. 1 Press LCD-OPEN to unlock the LCD monitor and swing open. 2 Press REWIND/SEARCH to rewind the tape. 3 Press PLAY to start playback. To adjust the volume: A Hold down VOLUME KEY until the volume setting screen appears. (See page 20). B Rotate VOLUME KEY to adjust the volume of the built-in speaker. To remove the volume setting screen, hold down VOLUME KEY again. • Adjust the picture on the LCD monitor if needed. (See page 23.) 4 Press STOP to stop playback. • When the tape reaches its beginning during rewind or rewind search, it will stop automatically. • If you press PLAY for more than 5 seconds, the Palmcorder will go into Repeat Playback mode when the tape reaches its end. The letter "R " will appear in the EVF and LCD monitor. To exit the Repeat Playback mode, turn the Palmcorder OFF. R PHONE Jack Note • When a tape recorded in LP mode on another digital video camera is played back on this unit, the picture may appear mosaic. • Using the LCD monitor reduces battery operating time. • You can connect earphones (not supplied) to the PHONE Jack. 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
27
Basic Operation
Basic Operation
Playback your Recordings
Playback your Recordings
1
Press LCD-OPEN
to unlock the LCD
monitor and swing open.
2
Press REWIND/SEARCH
to rewind
the tape.
3
Press PLAY
to start playback.
To adjust the volume:
A
Hold down
VOLUME KEY
until the
volume setting screen appears.
(See page 20).
B
Rotate VOLUME KEY
to adjust the
volume of the built-in speaker. To
remove the volume setting screen,
hold
down
VOLUME KEY
again.
•Adjust the picture on the LCD monitor if
needed. (See page 23.)
4
Press STOP
to stop playback
.
• When the tape reaches its beginning
during rewind or rewind search, it will
stop automatically.
• If you press PLAY for more than 5
seconds, the Palmcorder will go into
Repeat Playback mode when the
tape reaches its end. The letter “R
”
will appear in the EVF and LCD
monitor. To exit the Repeat Playback
mode, turn the Palmcorder OFF.
2
REWIND
SEARCH
Button
VOLUME KEY
4
STOP
Button
3
PLAY Button
Built-in
Speaker
1
LCD-OPEN
Button
Playback using the LCD Monitor
You can also use the LCD monitor to
playback your recording.
R
Note
180°
90°
90°
You can place the Palmcorder on a table,
etc. for viewing. Rotate the LCD Monitor
180° and swing it up against the
Palmcorder body as shown.
PHONE
Jack
Before you begin
•
Connect the Palmcorder to a power
source. (See pages 11, 12.)
•
Insert a recorded cassette.
•
Set POWER to VCR.
• When a tape recorded in LP mode on
another digital video camera is played
back on this unit, the picture may appear
mosaic.
• Using the LCD monitor reduces battery
operating time.
• You can connect earphones (not
supplied) to the PHONE Jack.