Panasonic PVDV401D PVDV201 User Guide - Page 7
Getting Started, Cassette Insertion/Removal, Using the Light Optional
View all Panasonic PVDV401D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
BBeeffoorree UUssiinngg GGeettttiinngg SSttaarrtteedd Cassette Insertion/Removal Before you begin • If the Palmcorder is connected to a power source, the cassette can be inserted and ejected without turning the Palmcorder on. 1TAPE EJECT Switch • Connect the Palmcorder to a power source. (See pages 11, 12.) 1 Slide TAPE EJECT to open the 2 Cassette Compartment Cover. Insert a cassette record tab up, 3 window side facing out. Press PUSH TO CLOSE mark to 3PUSH TO close the Cassette Compartment Cover. CLOSE mark • To remove the cassette... Slide TAPE EJECT to open the Cassette Compartment Cover and pull the cassette Cassette Compartment Cover tape straight out. Hint to locate recording position when inserting cassette • When you insert a partially recorded cassette, use the Edit Search Function (see page 24) to visually confirm the point at which you want to start a new recording. Especially advisable when you want to add a recording to a tape that is already full. Note • If hand strap is tight it may prevent Cassette Compartment Cover from fully opening for tape insertion or ejection. Loosen hand strap if necessary. • When inserting the cassette, make sure it faces in the right direction and then push in completely. Using the Light (Optional) To brighten the natural colors in a scene. Built-in Light Mount Note • Using the light will reduce battery operating time. • Be sure to provide adequate ventilation if using Light in a hot environment for an extended period. • Be sure LIGHT is set to OFF when not in use. • Do not attempt to lift or carry the Palmcorder by holding the Enhancement Light. • If light bulb needs to be replaced, take Light to your nearest authorized servicenter. Before you begin • Connect the Palmcorder to a power source. (See pages 11, 12.) • Set POWER to CAMERA or M-CARD. 1 Slide Light into the Built-in Light Mount. Be sure it locks into place. 2 2LIGHT Button Press LIGHT to turn ON or OFF. LIGHT RELEASE Button To remove the Light: Press LIGHT RELEASE and slide the Light out of the mount. Caution This light becomes hot during operation. Make sure nothing covers the Light during operation. 7