Panasonic PVDV401D PVDV201 User Guide - Page 32

CCaarrdd FFeeaattuurreess Card PhotoShot You can record still images to a Memory Card. Before you begin • Connect the Palmcorder to a power source. (See pages 11, 12.) • Set POWER to OFF before inserting a Warning Memory Card. (See page 10.) • Memory Card will not work when DV interface Cable (i.LINK) is connected. 3PHOTOSHOT 2JOG KEY Button 1 Slide the M-CARD Lock Switch to unlock, then set POWER to M-CARD. • The POWER lamp lights red. • Be sure POWER is fully turned to M-CARD position. 2MENU Button M-CARD Lock • "PLAY: PUSH PLAY KEY" is Switch displayed for 10 seconds. 1 2 POWER (See page 33.) Press MENU to display CARD SETTING menu, then press JOG KEY Switch to select NORMAL or FINE . Image Resolution and Capacity (supplied 8 MB MultiMediaCard) REC Image Mode Resolution Capacity FINE 640 x 480 Approx. 60 images NORMAL 320 x 240 Approx. 240 images • The number of images given for each mode applies when all images are taken in same mode. • You can change recording modes at any time before capturing an image. • The number of images that can be captured may differ depending on the subject. After capturing an image, the number may not decrease, or it may decrease by two. This is normal. Warning • While "PROCESSING" is displayed, DO NOT turn off the Palmcorder or unplug the AC Adaptor (supplied) because this will cause irreversible damage to the memory. 3 • Press MENU to exit this menu. Press PHOTOSHOT to record an image. • The PhotoShot image is recorded to the Memory Card. • When SHUTTER is set to ON (see page 15), still pictures are recorded with a visual shutter effect and click sound. If set to OFF, the still image will be displayed only. Cautions for the Memory Card • While Memory Card data is being read, do not remove it, turn off the power, or subject unit to vibrations and shocks. • Do not leave the Memory Card in a place with high temperature, exposed to direct sunlight, or where electromagnetic waves and static electricity can be generated. • Electromagnetic waves, static electricity, malfunction of the Palmcorder or of the Memory Card itself could erase the data recorded on it. To prevent the loss of picture data, we recommend that you make a backup copy on the computer. • Do not bend or drop the Memory Card as this could damage it or the captured contents. • Do not touch the connector on the rear edge of the Memory Card with your fingers and take care that no dirt, dust or water enters it. • Do not affix other labels to the Memory Card face or back as Card insertion/removal may become impossible. 32 For assistance, please call : 1-800-211-PANA(7262) or send e -mail to : [email protected]