Pioneer AVHP5700DVD Owner's Manual - Page 71
Using subwoofer output, Boosting the subwoofer level, Using nonfading output, Audio Adjustments
UPC - 012562734668
View all Pioneer AVHP5700DVD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Audio Adjustments Section 16 Audio Adjustments 3 Touch c or d to select a desired level. Each time you touch c or d selects level in the following order: LOW (low)MID (mid)HIGH (high) Using subwoofer output This unit is equipped with a subwoofer output which can be turned on or off. ! When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. 1 Touch SUB WOOFER on the audio function menu. # When the subwoofer controller setting is FULL, you cannot select SUB WOOFER. 2 Touch c to turn subwoofer output on. # To turn subwoofer output off, touch d. 3 Touch b and then touch c or d to select the phase of subwoofer output. Touch d to select normal phase and NORMAL appears in the display. Touch c to select reverse phase and REVERSE appears in the display. 4 Touch b and then touch c or d to adjust the output level of the subwoofer. Each time you touch c or d increases or decreases the level of the subwoofer. +6 6 is displayed as the level is increased or decreased. 5 Touch b and then touch c or d to select cut-off frequency. Each time you touch c or d selects cut-off frequencies in the following order: 50Hz80Hz125Hz Only frequencies lower than those in the selected range are outputted from the subwoofer. Boosting the subwoofer level You can easily boost the subwoofer bass level by repeatedly pressing BOOST button. If the subwoofer is set to OFF, pressing BOOST button automatically sets the subwoofer to ON. % Press BOOST button to increase the subwoofer level. The subwoofer level 0-+6 is shown in the display. # To decrease the level, press BOOST button and hold. The subwoofer level is reset to 0 and then you can start again. Note You can also select the subwoofer level in the auido menu. Refer to Using subwoofer output on this page. Using nonfading output When the nonfading output setting is on, the audio signal does not pass through this units low pass filter (for the subwoofer), but is outputted through the RCA output. 1 Touch NON FADING on the audio function menu. # When the subwoofer controller setting is only FULL, you can select NON FADING. (Refer to page 89.) 2 Touch a to turn non fading output on. # To turn non fading output off, touch b. 3 Touch c or d to adjust the output level of the non fading. Each time you touch c or d increases or decreases the level of the non fading. +6 6 is displayed as the level is increased or decreased. En 71