Pioneer DEH-P5100UB Owner's Manual - Page 29
Switching the warning tone, Switching the auxiliary setting, Adjusting the brightness - setting clock
UPC - 012562945170
View all Pioneer DEH-P5100UB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Initial Settings Section 04 English 1 Use MULTI-CONTROL to select Clock in the initial setting menu. Refer to Adjusting initial settings on the previous page. 2 Push MULTI-CONTROL left or right to select the segment of the clock display you wish to set. Pushing MULTI-CONTROL left or right will select one segment of the clock display: Hour-Minute As you select segments of the clock display, the selected segment blinks. 3 Push MULTI-CONTROL up or down to put a clock right. Note You can match the clock to a time signal by pressing MULTI-CONTROL. ! If 00 to 29, the minutes are rounded down. (e.g., 10:18 becomes 10:00.) ! If 30 to 59, the minutes are rounded up. (e.g., 10:36 becomes 11:00.) Switching the warning tone If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. You can turn off the warning tone. 1 Use MULTI-CONTROL to select Warning tone in the initial setting menu. Refer to Adjusting initial settings on the previous page. 2 Press MULTI-CONTROL to turn warning tone on. # To turn warning tone off, press MULTI-CONTROL again. Switching the auxiliary setting Auxiliary devices connected to this unit can be activated individually. Set each AUX source to ON when using. For more information about connecting or using auxiliary devices, refer to Using the AUX source on page 33. 1 Use MULTI-CONTROL to select AUX1/ AUX2 in the initial setting menu. Refer to Adjusting initial settings on the previous page. 2 Press MULTI-CONTROL to turn AUX1/ AUX2 on. # To turn AUX off, press MULTI-CONTROL again. Switching the dimmer setting To prevent the display from being too bright at night, the display is automatically dimmed when the car's headlights are turned on. You can turn the dimmer on or off. 1 Use MULTI-CONTROL to select Dimmer in the initial setting menu. Refer to Adjusting initial settings on the previous page. 2 Press MULTI-CONTROL to turn dimmer on. # To turn dimmer off, press MULTI-CONTROL again. Adjusting the brightness You can adjust the display brightness. 1 Use MULTI-CONTROL to select Brightness in the initial setting menu. Refer to Adjusting initial settings on the previous page. 2 Push MULTI-CONTROL left or right to adjust the brightness level. 0 to 15 is displayed as the level is increased or decreased. # When dimmer is functioning, the brightness level can be adjusted 0 to 10. En 29