Pioneer DVJ 1000 Owner's Manual - Page 18

Before Operating (Connections) 2. Control cord connection for relay play By using the accessory control cord to connect two DJ players, automatic relay play can be performed between the two units. ( P.45) DVJ-1000 DIGITAL OUT AUDIO OUT R L CONTROL NORMAL DJ COMPOSITE VIDEO OUT S S PREVIEW OUT SYNC IN POWER OFF ON AC IN DVJ-1000 Accessory control cord DIGITAL OUT AUDIO OUT R L CONTROL NORMAL DJ COMPOSITE VIDEO OUT S S PREVIEW OUT SYNC IN POWER OFF ON AC IN 3. Connection to stereo amplifier (without DJ mixer) Connect CD or AUX input connector (do not connect to PHONO input connector) Stereo amplifier DVJ-1000 DIGITAL OUT Accessory audio cable AUDIO OUT R L CONTROL NORMAL DJ COMPOSITE VIDEO OUT S S PREVIEW OUT SYNC IN 4. Connection to component equipped with digital input connector CD recorder or amplifier with digital input connector, etc. Coaxial digital cable (sold separately) DVJ-1000 DIGITAL OUT AUDIO OUT R L CONTROL NORMAL DJ COMPOSITE VIDEO OUT S S PREVIEW OUT SYNC IN Setting the NORMAL/DJ switch (rear panel) When the unit is used normally as a DJ DVD player, the mode select switch should be set to the "DJ" position. If the switch position is changed during playback, playback will stop and after the stop, playback will begin from the beginning of the disc. When set to DJ (DJ mode): ¶ During DVD playback, the digital output connectors produce 2-channel linear PCM digital data, regardless of the selected audio signal format. In addition, subtitles and certain other functions and operations are not supported. ¶ During CD playback, the digital connector outputs only audio data without sub-codes. However, sampling frequency is fixed at 44.1 kHz. As a result, limitations of recording or other functions may be experienced when certain CD recorders or other components are connected. For details, consult the Operating Instructions for the component to be connected. ¶ Some functions may be limited or disabled during DVD playback ( P.7, "About DVD playback in DJ mode"). When set to NORMAL (NORMAL mode): ¶ The digital connector outputs digital data including sub-codes, but the player's DJ functions are disabled. ¶ When unsupported operations are attempted the message "NORMAL" will appear in the display. ¶ When power is turned ON, if the NORMAL/DJ switch is set to "NORMAL", the display shows the message "NORMAL". ¶ If you wish to use all ordinary functions during DVD playback, set the unit to NORMAL mode ( P.7, "About DVD playback in DJ mode"). 18