Pioneer FH-P5000MP Owner's Manual - Page 43
Digital Signal Processor
View all Pioneer FH-P5000MP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Digital Signal Processor Section 10 English 1 Press DSP to select the graphic equalizer. Press DSP until PWRFL appears in the display. # If the graphic equalizer has been previously set to an equalizer curve other than PWRFL then the title of that previously selected equalizer curve will be displayed instead of PWRFL. 2 Push Multi Control left or right to select an equalizer curve. Each pushing Multi Control left or right selects equalizer curves in the following order: PWRFLNTRLVOCALFLATCTM1 CTM2S-Bas Adjusting equalizer curves The factory supplied equalizer curves, with the exception of FLAT, can be adjusted to a fine degree (nuance control). 1 Recall an equalizer curve. See Recalling equalizer curves on the previous page. 2 Push Multi Control up or down to adjust the equalizer curve. Each pushing Multi Control up or down increases or decreases the equalizer curve respectively. +6 5 (or 6) is displayed as the equalizer curve is increased or decreased. # The actual range of the adjustments are different depending on which equalizer curve is selected. # The equalizer curve with all frequencies set to 0 cannot be adjusted. Adjusting 13-band graphic equalizer For CTM1 and CTM2 equalizer curves, you can adjust the level of each band. ! A separate CTM1 curve can be created for each source. (The built-in CD player and the multi-CD player are set to the same equalizer adjustment setting automatically.) If you make adjustments when a curve other than CTM2 is selected, the equalizer curve settings will be memorized in CTM1. ! A CTM2 curve can be created common to all sources. If you make adjustments when the CTM2 curve is selected, the CTM2 curve will be updated. 1 Recall the equalizer curve you want to adjust. See Recalling equalizer curves on the previous page. 2 Press DSP to select 13-band graphic equalizer. Press DSP until 50 appears in the display. # If 13-band graphic equalizer has been previously adjusted, the frequency of that previously selected will be displayed instead of 50. 3 Push Multi Control left or right to select the equalizer band to adjust. Each pushing Multi Control left or right selects equalizer bands in the following order: 50801252003155008001.25k 2.0k3.15k5.0k8.0k12.5k (Hz) 4 Push Multi Control up or down to adjust the level of the equalizer band. Each pushing Multi Control up or down increases or decreases the level of the equalization band. +6 6 is displayed as the level is increased or decreased. # You can then select another band and adjust the level. En 43