Pioneer FH-P5000MP Owner's Manual - Page 45
Using BBE sound, Digital Signal Processor
View all Pioneer FH-P5000MP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Digital Signal Processor Section 10 English # Check POS appears when neither Front-L nor Front-R is selected in the position selector mode (Posi). 4 Push Multi Control left or right to select the speaker to be adjusted. Each pushing Multi Control left or right selects the speaker in the following order: F-L (front left)F-R (front right)R-R (rear right)R-L (rear left)SubW (subwoofer) # You cannot select SubW when the subwoofer output is off. 5 Push Multi Control up or down to adjust the distance between the selected speaker and the listening position. Each pushing Multi Control up or down increases or decreases the distance. 400 0 is displayed as the distance is increased or decreased, if you have selected centimeters (cm). 160 0 is displayed as the distance is increased or decreased, if you have selected inches (inch). # You can adjust the distance for the other speakers in the same way. 2 Push Multi Control up to turn BBE on. BBE : 0 appears in the display. # To turn BBE off, press Multi Control down. 3 Push Multi Control left or right to adjust the level of BBE. Each pushing Multi Control left or right increases or decreases the level of BBE. +4 4 is displayed as the level is increased or decreased. Note Manufactured under license from BBE Sound, Inc. The mark BBE is a trademark of BBE Sound, Inc. Using BBE sound With BBE, playback very close to the original sound can be obtained by correction with a combination of phase compensation and high-range boost for the delay of the high-frequency components and the amplitude deviation occurring during playback. This function makes it possible to reproduce the dynamic sound field as if you are listening to a live performance. With BBE sound processing technology, you can adjust the level of BBE. 1 Press DSP to select SFC. Press DSP until SFC appears in the display. En 45