ProForm Power Zt8 Treadmill English Manual - Page 14
Tighten the four 5/16 x 1 Flat Head Screws
View all ProForm Power Zt8 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
10. With the help of a second person, hold the console assembly near the Right Handrail (87). See the inset drawing. Connect the Upright Wire (81) to the console wire. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Remove the wire tie from the Upright Wire. 10 Console Assembly Console Wire 81 Wire Tie 87 Console Wire 81 11. Set the console assembly on the Handrails (86, 87). Be careful not to pinch any wires. Insert the excess Upright Wire (81) into the Right Handrail. Attach the console assembly with six #8 x 1/2" Screws (1), four 5/16" x 5/8" Screws (4), and four 5/16" Star Washers (11). Start all ten Screws, and then tighten them. Tighten the four 5/16" x 1" Flat Head Screws (28) and the two 5/16" x 1" Screws (8) (only one side is shown). 11 81 87 11 48 28 1 1 Console Assembly 86 11 4 1 1 14