Samsung WF457ARGSGR/A2 User Manual Ver.1.0 (English, French, Spanish) - Page 20
Installing Your Washer
View all Samsung WF457ARGSGR/A2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installing your washer INSTALLING YOUR WASHER Before STEP 5 is complete, do not plug the power cord into a wall socket. CAUTION Packaging materials can be dangerous to children; keep all packaging material (plastic bags, polystyrene, etc.) well out of the reach of children. WARNING Installation flow chart Selecting a location Removing the shipping bolts (*Drum only) Connecting the water and the drain Please check again before steps. Adjusting the levelling feet Powering your washing machine [Running a test cycle] Run a test cycle (Rinse+Spin) with small amount of laundary (about 4~5 Towels) Does your washer have excess vibration Yes or noise? Running a Calibration mode (Refer to the following No description) Finish the installation STEP 1 Selecting a location Before you install the washer, make sure the location: • Has a hard, level surface without carpeting or flooring that may obstruct ventilation Is away from direct sunlight • Has adequate ventilation • Is not exposed to freezing temperatures (temperatures are never below 32 °F or 0 °C) • Is away from heat sources such as oil or gas • Has enough space so that the washer doesn't stand on its power cord STEP 2 Removing the shipping bolts Before installing the washing machine, you must remove all shipping bolts from the back of the unit. 1. Hold the shipping bolt with your hand and pull it through the wide section of the hole. Repeat for each shipping bolt. 2. Fill the holes with the supplied bolt hole covers. 3. Store the shipping bolts in a safe location where they can be easily retrieved in the event that you have to move the washing machine in the future. 20_ Installing your washer WF457ARG-03153A-04_EN.indd 20 2012-08-31 12:30:21