Samsung WF457ARGSGR/A2 User Manual Ver.1.0 (English, French, Spanish) - Page 21
STEP 3, Connecting the water and the drain
View all Samsung WF457ARGSGR/A2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
01 INSTALLING YOUR WASHER STEP 3 Connecting the water and the drain Connecting the water supply hose Do not connect multiple water supply hoses. This may result in a water leakage and electric CAUTION shock due to the water leakage. If the hose is too short, replace the hose with a longer, high pressure hose. 1. Connect one end of the COLD water supply hose to the COLD water supply intake at the back of the washer. 2. Tighten part (A) by hand until it is snug, then make twothirds of a turn with a wrench. 3. On the other end of the hose, check for one rubber washer per hose and install each water supply hose to the faucet. Make sure the hose with the printed word HOT is attached to the HOT faucet. 4. Tighten part (A) by hand until it is snug, then make twothirds of a turn with a wrench. For the correct water use, connect both the HOT and COLD water faucets. If either or both are not connected, an "nF" (no fill) error can occur. After you have connected the water supply hose to the faucet, ensure that it is connected correctly by pulling the water supply hose downwards. Check if the water supply hose is not twisted or bent. WARNING If the hose is twisted or bent, there is a danger of a water leakage and electric shock due to the water leakage. 5. Turn on the HOT and COLD water supply and check all connections at the water intake and the faucet for leaks. Cold Hot Rubber Washer A WF457ARG-03153A-04_EN.indd 21 Installing your washer _21 2012-08-31 12:30:21