Sanyo WF10 Instruction Manual, PLV-WF10 - Page 13

CONNECTING PROJECTOR SERIAL PORT IN TERMINAL If you control a projector by computer, you must connect a cable (not provided) from your computer to this terminal. SERIAL PORT OUT TERMINAL This terminal outputs signal from SERIAL PORT IN. More than two projectors can be controlled with one computer by connecting SERIAL PORT IN. of another projector to this terminal. DVI AUDIO CONTROL PORT R L R/Pr G/Y B/Pb H/HV V (MONO) AUDIO CONTROL PORT R L VIDEO/Y C S-VIDEO (MONO) AUDIO R L R/C JACK SERIAL PORT IN SERIAL PORT OUT (MONO) AUDIO OUT R L RESET (MONO) USB INPUT 3 INPUT 2 INPUT 1 USB PORT (Series B) This port is used to control a projector with computer. It is also used to control computer with Remote Control of this projector. (Refer to P41, 43.) Connect USB port of computer to this port. R/C JACK When using Wired / Wireless Remote Control Unit as Wired Remote Control, Connect Wired Remote Control Unit to this jack with Remote Control Cable (supplied). (Refer to page 17.) RESET BUTTON This projector uses a micro processor to control a unit. Occasionally, this micro processor may malfunction and need to be reset. This can be done by pressing RESET button with a pen, which will shut down and restart unit. Do not use RESET function excessively. AUDIO OUTPUT JACKS Connect an external audio amplifier to these jacks. (Refer to P14, 15.) 13