Sanyo WF10 Instruction Manual, PLV-WF10 - Page 46
Caution
UPC - 086483050046
View all Sanyo WF10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
APPENDIX LAMP REPLACEMENT When the life of the Projection Lamp of this projector draws to an end, the LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the projection lamp with a new one promptly. LAMP REPLACE INDICATOR Allow a projector to cool, for at least 45 minutes before you open Lamp Cover. The inside of a projector can become very hot. CAUTION For continued safety, replace with a lamp assembly of the same type. Do not drop a lamp assembly or touch a glass bulb! The glass can shatter and may cause injury. Follow these steps to replace lamp assembly. 1 Check number of lamp to be replaced on Lamp Status Display. 2 Turn off a projector and disconnect AC Power Cord. Allow a projector to cool for at least 45 minutes. 3 Loosen 3 screws on Lamp Cover and remove Lamp Cover. (See right figure.) 4 Loosen 2 screws and pull out Lamp Assembly to be replaced by grasping handle. 5 Replace Lamp Assembly with a new one and tighten 2 screws. Make sure that Lamp Assembly is set properly 6 Replace Lamp Cover and tighten 3 screws. LAMP COVER SCREWS LAMP 1 LAMP 2 7 Connect AC Power Cord to a projector and turn projector on. 8 Reset Lamp Replacement Counter. (Refer to section "Lamp Counter Reset" on page 42.) NOTE : Do not reset LAMP REPLACEMENT COUNTER when lamp is not replaced. SCREWS Make sure which number of lamp needs to be replaced on Lamp Status Display. Figure shows case of replacing LAMP 2. CAUTION : DO NOT OPERATE A PROJECTOR WHILE ANY OF LAMPS IS REMOVED. IT MAY RESULT IN MALFUNCTIONS, FIRE HAZARD, OR OTHER ACCIDENTS. NOTES ON LAMP REPLACEMENT To maintain quality of picture (better balance of color and brightness in entire screen), we recommend replacing all 2 lamps at a time. 46