Sanyo WF10 Instruction Manual, PLV-WF10 - Page 54

APPENDIX CONFIGURATIONS OF TERMINALS DVI-I TERMINAL (DIGITAL/ANALOG) This terminal accepts only Digital (TMDS) or Analog (RGB) output signal. Connect display output terminal of computer to this terminal with DVI cable (supplied). Pin Configuration C1 C2 C1 Analog Red Input C2 Analog Green Input C3 Analog Blue Input C4 Analog Horiz. sync C5 Analog Ground (R/G/B) 12345678 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 C3 C4 C5 1 T.M.D.S. Data2- 9 T.M.D.S. Data1- 17 T.M.D.S. Data0- 2 T.M.D.S. Data2+ 10 T.M.D.S. Data1+ 18 T.M.D.S. Data0+ 3 T.M.D.S. Data2 Shield 11 T.M.D.S. Data1 Shield 19 T.M.D.S. Data0 Shield 4 No Connect 12 No Connect 20 No Connect 5 No Connect 13 No Connect 21 No Connect 6 DDC Clock 14 +5V Power 22 T.M.D.S. Clock Shield 7 DDC Data 15 Ground (for +5V) 23 T.M.D.S. Clock+ 8 Analog Vert. sync 16 Hot Plug Detect 24 T.M.D.S. Clock- CONTROL PORT CONNECTOR Terminal : Mini DIN 8-PIN Connect control port (PS/2, Serial or ADB port) on your computer to this terminal with Control Cable (supplied). Pin Configuration 876 5 43 21 PS/2 1 ----2 CLK 3 DATA 4 GND 5 ----6 ----7 GND 8 ----- Serial R X D --------GND RTS T X D GND GND ADB ----ADB ----GND GND SERIAL PORT IN/OUT TERMINAL Connect serial port output terminal of computer to this terminal with Serial Cable (not supplied). Pin Configuration 54321 9 87 6 USB PORT TERMINAL 1 ----2 RxD 3 TxD 4 ----5 Ground 6 ----7 ----8 ----9 ----- Pin Configuration Connect USB port output terminal of computer or peripheral equipment to this terminal with USB port Cable (not supplied). 1 Vcc 21 2 - Data 3 + Data 34 4 Ground 54