Sanyo WF10 Instruction Manual, PLV-WF10 - Page 41

SETTING Remote control Remote control This projector has eight different remote control codes; the factoryset normal code (Code 1) and the other seven codes (Code 2 to Code 8). This switching function prevents remote control operation mixture (jam) when operating several projectors or video equipment together. For example operating projector in "Code 7," both projector and Remote Control Unit must be switched to "Code 7." To change the code of Projector; To change the Remote control code of the projector used in ONSCREEN MENU is selectable from Code 1 to Code 8. To change the code of the Remote Control Unit; To change the remote control code of the Remote Control Unit, set the DIP switches 1-3 inside the battery compartment box of the Remote Control Unit. (Refer to P17.) When pressing SELECT button at Remote control, Remote control code Menu appears. USB This Projector is equipped with USB port for interactive operation USB between a projector and computer. Set mode following steps below. Wireless Mouse mode Select " " when controlling a computer with Remote Control of this projector. Projector mode Select " " when controlling a projector with computer. NOTE: This is provided not for basic operation but for future use. Move a pointer to item and then press POINT LEFT/RIGHT button(s). Key lock This function locks the operation of the projector's control panel and the remote control. This cancels the Key lock function. This locks operation of the projector's control panel. This locks operation of the remote control. If the projector's control panel accidentally becomes locked and you do not have the remote control nearby, disconnect the AC cord to turn off the power, and then while pressing a SELECT button, reinsert the AC cord, This will cancel the projector's control panel lock. Key lock 41