Sanyo WF10 Instruction Manual, PLV-WF10 - Page 28

COMPUTER INPUT When a input signal is digital from DVI terminal, refer to chart below. ON-SCREEN DISPLAY D-VGA D-SVGA D-XGA D-SXGA 1 RESOLUTION 640 x 480 800 x 600 1024 x 768 1280 x 1024 H-Freq. (kHz) 31.469 37.879 48.363 63.981 V-Freq. (Hz) 59.940 60.317 60.004 60.020 ON-SCREEN DISPLAY D-SXGA 2 D-SXGA 3 D-UXGA RESOLUTION 1280 x 1024 1280 x 1024 1600 x 1200 NOTE : Specifications are subject to change without notice. H-Freq. (kHz) 60.276 31.65 75.00 V-Freq. (Hz) 58.069 29.8 60.00 PC ADJUSTMENT AUTO PC ADJUSTMENT Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots and Picture Position to conform to your computer. Auto PC Adjustment function can be operated as follows. Auto PC Adj. 1 Press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button to move a red frame pointer to PC ADJUST Menu icon. 2 Press POINT DOWN button to move a red frame pointer to AUTO PC Adj. icon and then press SELECT button twice. This Auto PC Adjustment can be also executed by pressing AUTO PC ADJ. button on Top Control or on Remote Control Unit. Store adjustment parameters. Adjustment parameters from Auto PC Adjustment can be memorized in this projector. Once parameters are memorized, setting can be done just by selecting Mode in PC SYSTEM Menu (P26). Refer to step 3 of MANUAL PC ADJUSTMENT section (P30). NOTE G Fine sync, Total dots and Picture Position of some computers can not be fully adjusted with this Auto PC Adjustment function. When image is not provided properly through this function, manual adjustments are required. (Refer to page 29, 30.) G Auto PC Adjustment function cannot be operated in Digital Signal input on DVI terminal and "480i", "575i", "480p", "575p", "720p (HDTV)", "1035i (HDTV)", "1080i50 (HDTV)" or "1080i60 (HDTV)" is selected on PC SYSTEM Menu (P26). PC ADJUST MENU PC ADJUST Menu icon Move a red frame pointer to AUTO PC Adj. icon and press SELECT button. 28