Sanyo WF10 Instruction Manual, PLV-WF10 - Page 14

CONNECTING PROJECTOR CONNECTING TO COMPUTER Cables used for connection (✽ = Cables are not supplied with this projector.) • DVI-VGA Cable • Control Cable for PS/2 port, Serial port, or ADB port • MAC/VGA Adapter • DVI Cable • BNC Cable (BNC x 5) ✽ • Audio Cables (RCA x 2) ✽ NOTE : When connecting cable, power cords of both a projector and external equipment should be disconnected from AC outlet. Turn a projector and peripheral equipment on before computer is switched on. IBM-compatible computers or Macintosh computers (VGA / SVGA / XGA / SXGA / WXGA / UXGA Desktop type Laptop type 14 Monitor Output BNC Cable ✽ Monitor Output Monitor Output Audio Output Serial port PS/2 port ADB port MAC/VGA Adapter Set slide switches following chart below. Audio Cable (stereo) ✽ Control Cable Control Cable Control Cable for Serial Port for PS/2 Port for ADB Port Terminal Terminal Terminal DVI Cable DVI-VGA Cable Terminals of a Projector Switches of MAC/VGA Adapter MAC/VGA ADAPTER ON ON DIP 123456 OFF INPUT 1 INPUT 2 DVI AUDIO CONTROL PORT R L R/Pr G/Y B/Pb H/HV V (MONO) AUDIO CONTROL PORT R L VIDEO/Y C S-VIDEO (MONO) AUDIO R L R/C JACK RESET (MONO) SERIAL PORT IN SERIAL PORT OUT AUDIO OUT R L (MONO) USB INPUT 3 AUDIO OUT Audio Cable (stereo) ✽ Use one of these Control Cables corresponding with terminal of your computer. Set switches as shown in table below depending on RESOLUTION MODE that you want to use before your turn on a projector and computer MODE SWITCHES 1 2 3 4 5 6 13"MODE (640 x 480) ON ON OFF OFF OFF OFF 16"MODE (832 x 624) OFF ON OFF ON OFF OFF 19"MODE (1024 x768) OFF ON ON OFF OFF OFF 21"MODE (1152 x 870) ON ON ON ON OFF OFF Audio Input External Audio Equipment Audio Amplifier Audio Speaker (stereo)