Sanyo WXU300 Instruction Manuals, PLC-WXU300 - Page 45
Input search, Auto PC adj°, Auto Keystone, Auto setup
UPC - 086483074226
View all Sanyo WXU300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Setting Auto setup This function enables Input search, Auto Keystone correction and Auto PC adjustment by pressing the AUTO SETUP button on the top control or the AUTO SET button on the remote control. Settings for those functions can be altered as follows: Input search This function detects the input signal automatically. When a signal is found, the search will stop. Use the Point ▲▼ buttons to select one of the following options. Off Input search will not work. On1.......... Input search works under the following situation. - When pressing the AUTO SETUP button on the top control. - When pressing the AUTO SET button on the remote control. On2.......... Input search works under the following situation. - When turning on the projector by pressing the ON/STAND-BY button on the top control or the remote control. - When pressing the AUTO SET button on the remote control. - When pressing the AUTO SETUP button on the top control. - When the current input signal is cut off.* * If the No show or Freeze function is active, cancel it to activate the Input search. It is also unavailable when OnScreen menu is displayed. Auto PC adj. On Enables Auto PC adjustment when pressing the AUTO SET button on the remote control or the AUTO SETUP button on the top control. Off Disables Auto PC adjustment. Auto Keystone Auto Always works and corrects keystone distortion according to the projector's tilt. Manual . . . . Works only when pressing the AUTO SETUP button on the top control or the AUTO SET button on the remote control. Off Disables Auto Keystone. Note: • While Input search is set to On1 or On2, the status of Input and Lamp are displayed every time the signal is switched. • During Input search is in progress, if the INPUT button on the top control, the COMPUTER1/2, HDMI, SVIDEO, COMPONENT or the VIDEO button on the remote control, the MENU button or the ON/STAND-BY button is pressed, Input search will stop. If the INPUT button is pressed, the Input search will go back to the current search signal. If the COMPUTER 1/2, HDMI, VIDEO, S-VIDEO or COMPONENT button is pressed, Input search will go back to the button's input signal. Auto setup Picture in Picture Standby mode Network Note: • Input search, Auto PC adj. and Auto Keystone cannot be set Off at the same time. • Auto Keystone corrects vertical distortion only, not correct horizontal distortion. • The Auto Keystone function cannot work when the Ceiling feature is set On in the Setting menu (p.50). • Perfect correction of the image distortion cannot be ensured with the Auto setup function. If the distortion is not corrected properly by pressing the AUTO SETUP or AUTO SET button, adjust manually by pressing the KEYSTONE button on the remote control or selecting Keystone in the Setting menu (pp.23, 46). • Fine sync., Total dots, Horizontal and Vertical position of some computers cannot be fully adjusted with the Auto PC adjustment function. When the image is not provided properly with this operation, manual adjustments are required (pp.31-32). • Only the last selected input source can be detected. 45