Sanyo WXU300 Instruction Manuals, PLC-WXU300 - Page 67
Power management does
UPC - 086483074226
View all Sanyo WXU300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Appendix No image - Check the connection between your computer or video equipment and the projector. See pages 14-16. - See if the input signal is correctly output from your computer. Some laptop computers may need to change the setting for monitor output when connecting to a projector. See your computer's instruction manual for the setting. - It takes about 30 seconds to display an image after turning on the projector. See page 18. - Check the Input signal, color system, video system or computer system mode. - Make sure the temperature is not out of the specified Operating Temperature (41˚F-95˚F [5˚C-35˚C]). - When No Show is operating, the image cannot be displayed. Press the NO SHOW button or any other button on the remote control. No sound - Check the audio cable connection from audio input source. - Adjust the audio source. - Press the Volume + button. See page 24. - Press the Mute button. See page 24 - When the AUDIO OUT is plugged-in, the projector's built-in speaker is not available. - Is the image projected? You will hear the sound only when the image is projected. The color is strange. - Check the Input signal, color system, video system or computer system mode. - Make sure the Blackboard is not selected on Image select menu. See pages 33,40. Some displays are not seen during the operation. - Check the Display function. See page 46. Auto PC adjustment function does not work. 30. - Check the Input signal. Auto PC function can not work when 480p, 575p, 720p, 480i, 575i, 1035i or 1080i is selected. See Page - The icon is not available in grayout when the digital signal is input. The setting does not remain after turning off power. - Make sure you selected Store after adjusting setting. Some settings can not be stored if not registered with "Store". See pages 35,42. Power management does not work. - Power management function can not work while Freeze or No Show function is running. See page 52. Capture function does not work. - Check the connection and the input signal to see if there is signal. Auto setup does not work properly. - Make sure Off is not selected at any function of Auto setup. See page 45 - Make sure On is not selected at the Ceiling function. See page 50. Auto keystone function does not work even when the projector is tipped. - Make sure the Auto keystone function is not set to Manual. Press the AUTO SETUP button on the top control. See pages 23,45 67