Sanyo WXU300 Instruction Manuals, PLC-WXU300 - Page 9
Rear Terminal - manual
UPC - 086483074226
View all Sanyo WXU300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Rear Terminal * Part Names and Functions ① ② ③ ④ ⑤ ⑩ ⑨ ⑧ ⑦⑥ ① CONTROL PORT When the projector is controlled by a computer, connect to this jack with serial control cable. ② COMPUTER IN 1 / COMPONENT IN Connect output signal from a computer, RGB scart 21-pin video output or component video output to this terminal (pp.14,16). ③ COMPUTER IN 2 / MONITOR OUT - Connect computer output to this terminal (p.14). - This terminal can be used to output the incoming analog RGB signal from COMPUTER IN 1/ COMPONENT IN terminal to the other monitor (p.14). ④ HDMI Connect the HDMI signal (including sound signal) from video equipment or the DVI signal from computer to this terminal (pp.14, 16). ⑤ LAN Connection Terminal Connect the LAN cable (refer to the owner's manual of "Network Set-up and Operation"). ⑥ S-VIDEO IN Connect the S-VIDEO output signal from video equipment to this jack (p.15). ⑦ AUDIO OUT (VARIABLE) Connect an external audio amplifier to this jack (pp.14-16). This terminal outputs sound from AUDIO IN terminal (⑧ or ⑨). ⑧ COMPUTER 1 / COMPUTER 2 AUDIO IN Connect the audio output (stereo) from a computer or video equipment connected to ② or ③ to this jack. (pp14, 16) ⑨ AUDIO IN Connect the audio output signal from video equipment connected to ⑥ or ⑩ to this jack. For a mono audio signal (a single audio jack), connect it to the L (MONO) jack (p.15). ⑩ VIDEO IN Connect the composite video output signal to this jack (p.15). * is registered trademarks of HDMI Licensing, LLC.