Schwinn 490 Elliptical Assembly and Owners Manual - Page 14
Attach the Rail Assembly to the Main Assembly. Once attached, cut the Shipping Zip-Ties
View all Schwinn 490 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
3. Attach the Rail Assembly to the Main Assembly. Once attached, cut the Shipping Zip-Ties from the Rail Assembly and Attach to the Incline (Lift) Motor Arm of the Main Assembly. In order to avoid possible serious injury, when attaching the Rail Assembly to the Main Assembly be careful to avoid fingers or hands being caught or pinched. Do not place fingers or hands below any pivoting parts of the Rail Assembly. Note: S ome parts can be slightly shifted to assist with alignment. At first, only finger tighten hardware. Then with all of hardware started, FULLY tighten. * Hardware is not supplied in the Hardware Bag. Remove all hardware from the Rail Assembly before attaching it. 12 X4 6mm * X4 * X8 6mm A Incline (Lift) Motor Arm 14
14
12
X4
*
X4
6mm
*
6mm
X8
A
3.
Attach the Rail Assembly to the Main Assembly. Once attached, cut the Shipping Zip-Ties
from the Rail Assembly and Attach to the Incline (Lift) Motor Arm of the Main Assembly.
In order to avoid possible serious injury, when attaching the Rail Assembly to the Main Assembly be
careful to avoid fingers or hands being caught or pinched. Do not place fingers or hands below any
pivoting parts of the Rail Assembly.
Note:
Some parts can be slightly shifted to assist with alignment. At first, only finger tighten hardware. Then with all of
hardware started, FULLY tighten.
* Hardware is not supplied in the Hardware Bag. Remove all hardware from
the Rail Assembly before attaching it.
Incline (Lift)
Motor Arm