Schwinn 490 Elliptical Assembly and Owners Manual - Page 9

SPECIFICATIONS / BEFORE ASSEMBLY Power Requirements: 120V 220V Operational Voltage: 110-127V AC, 60Hz 220V - 240V AC, 50Hz Operating Current: 2A 2A Maximum User Weight: 150 kg (330 lb) Total Surface Area (footprint) of equipment: 12,723 cm2 Maximum Pedal Height - with full incline: 28.3 in ( 72 cm) Machine Weight: approx. 84.8 kg (187 lb) This product complies with the European Radio Equipment Directive 2014/53/EU DO NOT dispose of this product as refuse. This product is to be recycled. For proper disposal of this product, please follow the prescribed methods at an approved waste center. 86.2 cm ( 33.9 in ) 172.6 cm ( 68 in ) 147.6 cm ( 58.1 in ) Before Assembly Select the area where you are going to set up and operate your machine. For safe operation, the location must be on a hard, level surface. Allow a minimum workout area of 82.1 in x 57.9 in (208.5 cm x 147.1 cm). Keep the workout area clear 0.6 m (24 in) along the side used to access the machine and to the rear of the machine. Be sure that the workout space you are utilizing has adequate height clearance, taking into consideration the height of the user and the maximum incline of the elliptical machine. Estimated time to assemble the machine is 60 - 90 minutes. NOTICE: Inspect the machine for damaged parts due to delivery. If 2.1 m (82.1 in) damage is found, contact Customer Service (if inside US/ Canada) or your local distributor (if outside US/Canada) for assistance. 0.6 m ( 24 in ) Basic Assembly Follow these basic points when you assemble your machine: 1.5 m (57.9 in) • Read and understand the "Important Safety Instructions" before assembly. 0.6 m ( 24 in ) • Collect all the pieces necessary for each assembly step. • Using the recommended wrenches, turn the bolts and nuts to the right (clockwise) to tighten, and the left (counterclockwise) to loosen, unless instructed otherwise. • When attaching 2 pieces, lightly lift and look through the bolt holes to help insert the bolt through the holes. • The assembly requires 2 people. • Do not use any power tools for assembly. Machine Mat The Schwinn™ Machine Mat is an optional accessory that helps keep your workout area clear and adds a layer of protection to your floor. The rubber machine mat provides a non-slip, rubber surface which limits static discharge and reduces the possibility of display errors. If possible, put your Schwinn™ Machine Mat in your selected workout area before you begin assembly. To order the optional machine mat, contact Customer Service (if purchased in US/Canada) or your local distributor (if purchased outside US/Canada). 9