Schwinn 490 Elliptical Assembly and Owners Manual - Page 48

Condition/Problem No speed/RPM reading Resistance does not change (machine turns on and operates) Incline does not adjust (machine turns on and operates) Things to Check Check data cable integrity Check data cable connections/orientation Check magnet position (requires shroud removal) Check Speed Sensor (requires shroud removal) Check data cable integrity Check data cable connections/orientation Check Servo Motor (requires shroud removal) Check Console display for damage Resistance handlebar connection Check data cable connections/orientation Check Console display for damage Incline handlebar connection Incline Adjuster Assembly (requires shroud removal) Console display shows "Incline Cooling" error code Solution All wires in cable should be intact. If any are cut or pinched, replace cable. Be sure each cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Magnet should be in place on pulley. Speed sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. All wires in cable should be intact. If any are visibly pinched or cut, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Replace Servo Motor if not functioning properly. Check for visual sign that console display is cracked or otherwise damaged. Replace Console if damaged. Be sure cable from right Upper Handlebar and cables to Console are secure and undamaged. If the above steps do not resolve the problem, contact Customer Service (if inside US/Canada) or your local distributor (if outside US/Canada). Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Check for visual sign that console display is cracked or otherwise damaged. Replace Console if damaged. Be sure cable from left Upper Handlebar and cables to Console are secure and undamaged. Be sure Incline Adjuster Assembly is attached to Incline Motor drive screw. Additional incline adjustments are disabled for a few minutes to protect the motor from over heating. Allow the lift motor to cool, and then resume your workout. If the above steps do not resolve the problem, contact Customer Service (if inside US/Canada) or your local distributor (if outside US/Canada). 48