Schwinn 490 Elliptical Assembly and Owners Manual - Page 30

Moving the Machine Use the Transport Handle / Rear Step and Transport Wheels to move the machine. The Transport Handle / Rear Step is located in the middle of the Rail Assembly at the rear of the machine. Tilt the machine forward by lifting upward with the Transport Handle / Rear Step until the weight is on the Transport Wheels. Roll the machine on the transport wheels to a new location. Lower your machine slowly into its new location without injury to your head or fingers. Do not use the handlebars, Console Mast, or the Console to lift or move the machine. Injury to you or damage to the machine can occur. The machine may be moved by one or more persons depending on their physical abilities and capacities. Make sure that you and others are all physically fit and able to move the machine safely. Place the machine on a clean, hard, level surface, free from unwanted material or other objects that may hamper your ability to move freely. A rubber mat should be used below the machine to prevent the release of static electricity and protect your flooring. To prevent unsupervised operation of the machine always turn the power switch to Off and disconnect the power cord from the wall outlet and machine power input. Place the power cord in a secure location. Transport Handle / Rear Step Leveling the Machine The machine needs to be leveled if your workout area is uneven or if the Rail Assembly is slightly off the floor. To adjust: 1. Place the machine in your workout area. 2. Safely stand on the Rear Step for approximately 20 seconds. 3. Step off the machine. 4. Loosen the locking nuts and adjust the levelers until they all contact the floor. Do not adjust the levelers to such a height that they detach or unscrew from the machine. Injury to you or damage to the machine can occur. 5. Adjust until the machine is level. Tighten the locking nuts. Make sure the machine is level and stable before you exercise. 30