Sharp ER-A450T Dealer Knowledge Book - Page 18
Quick Start Procedures
View all Sharp ER-A450T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Quick Start Procedures QUICK START PROCEDURES For a quick reference procedure for using the LOGOCONV.exe with the ER-A450T, please use the below sequential steps outlined in the chart below. Step PC Side 1 Connect the PC to the ER-A450 Step ER-A450T Side 2 Set SRV Job #903-A: "6" (38,400 bps ) 3 Set SRV job #912-D: "1, 2, 4, or 5" 4 Launch the LOGOCONV.exe at the PC 5 Select Send LOGO1 or LOGO2 to the ECR and click [OK] 6 Select the previously created logo image and click [Open ] 7 View the image to verify that it is the correct one and click [ Send ] 9 Set the communications settings as follows; Baud Rate: 38,400 Protocol: SIO(Manual) Com Port: Com1 or Com2 (based on your PC) Click [ OK ] when ready 10 The PC will display the ECRCOM TRANSMIT message which will indicate the transmission of the image data 8 At the ER-A450T, enter the following key sequence in SRV mode; 998 FOR ] ---> [ CA/AT ] 11 The ER-A450T will display the byte block count 12 Perform the PGM (SRV) Reset Designs and specifications are subject to change without notice. Page / 17