Sharp XL-HP500 Operation Manual - Page 24

XL-HP500W Recording to a cassette tape ENGLISH Before recording: ! When recording important selections, make a preliminary test to ensure that the desired material is properly recorded. ! SHARP is not liable for damage or loss of your recording arising from malfunction of this unit. ! The volume and sound controls can be adjusted with no effect on the recorded signal (Variable Sound Monitor). ! For recording, use only normal tapes. Do not use metal or CrO tapes. " Recording from a CD (CDs) You can record the desired CD using the DISC SELECT - ( 1 - 3) buttons. 1 Press the ON/STAND-BY button to turn the power on. 2 Press the CD button and load the desired disc. 3 Load a cassette into the cassette compartment with side A facing you. Wind past the leader of the tape, on which recording cannot be performed. 4 Press the button to choose one side or both sides. ... To record on both sides. ... To record on only one side. Tape Recording 5 Press the button. Recording will be paused. 6 Press one of the DISC SELECT - ( 1 - 3) buttons to start recording. ! To record on both sides, begin on side A. (If recording is started from side B, the tape will not switch over to side A.) ! Recording is started from the selected CD. When the play- back of the last track is finished or the end of the tape is reached, the CD and the cassette will stop automatically. ! CD playback will start approximately 7 seconds after the tape starts. E-23 02/8/6 XL-HP500W(A)3.fm