Sony Ericsson T28 World User Guide - Page 7

Charging the Battery EricssonNoMtofboilreCCoommmmerucniiaclatUisoens AB 1. Make sure that the battery is attached to the phone. 2. Connect the charger to the electrical outlet. 3. Connect the charger to the phone as shown. The flash symbol on the plug must face upwards. Note! The electrical plug may look different depending on the electrical outlet in your country. Do not connect it to any other item than your Ericsson Travel Charger CTR-10. It must not be disconnected from the charger when plugged into the electrical outlet. To indicate charging: • the indicator on the top of the phone shows a steady red light (or green, if the phone is switched on) • the message Charging only is shown in the display • the battery meter in the display pulses continuously Note! If you charge a new battery that is empty, or a battery that has not been used for a long time, it may take a while until you get an indication of charging in the display. An Ericsson-approved battery is indicated by Ericsson Optimized charging each time you start charging the battery when the phone is switched on. For the best charging, talk and standby times in the long run, we recommend that you use only Ericsson-approved batteries with your phone. Batteries that are not Ericsson-approved are charged slowly for safety reasons. These are indicated by Charging alien battery each time you start charging the battery when the phone is switched on. Tip! You can use the phone while the battery is being charged. However, this lengthens the charging time. Preparing Your Phone for Use 7