Sony HT-SS2000 Operating Instructions - Page 27
To cancel Auto Calibration, Press AMP MENU, then press, AUTO CAL., Confirm the measurement, result. - speaker stands
UPC - 027242712133
View all Sony HT-SS2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Getting Started Performing Auto Calibration TV INPUT TV ?/1 SLEEP DMPORT AV ?/1 ?/1 SYSTEM STANDBY VIDEO 1 VIDEO 2 VIDEO 3 DVD SAT TV SA-CD/CD TUNER 2CH A.F.D. MOVIE MUSIC AMP MENU 123 AUTO CAL 456 7 >10/ - CLEAR D.TUNING 89 D.SKIP MEMORY DVD MENU 0/10 ENTER FM MODE DISPLAY TOOLS MUTING F TV VOL MASTER VOL G g f RETURN/EXIT MENU ?/1 switch Input buttons AMP MENU AUTO CAL MUTING MASTER VOL +/- Press AMP MENU, then press AUTO CAL. You can also select "A.CAL YES" in the A. CAL menu. The following appears on the display. A.CAL [5] t A.CAL [4] t A.CAL [3] t A.CAL [2] t A.CAL [1] The measurement process will take approximately 30 seconds to complete. The table below shows the display when measurement starts. Measurement for Speaker existance Speaker gain, distance, frequency response Sub woofer gain and distance Display TONE T.S.P. WOOFER Note You cannot measure the speaker height of the surround speakers. Set this value using "SUR POS." parameters in the SYSTEM menu (page 36). Tip When Auto Calibration starts: - Stand some distance from the speakers and the listening position to avoid measurement failure. This is because test signals are output from the speakers during measurement. - Avoid making noise to get a more accurate measurement. To cancel Auto Calibration The Auto Calibration function will be canceled when you do the following during the measurement process: - Press ?/1 or MUTING. - Press input buttons on the remote or INPUT SELECTOR on the receiver. - Change the volume level. - Press AUTO CAL again. Confirming/saving the measurement results 1 Confirm the measurement result. When the measurement ends, a beep sounds and the measurement result appears on the display. Measurement Display result When the measurement process completes properly SAVE When the measurement process fails ERROR XXXX Explanation Proceed to step 2. See "When error codes appear" (page 28). continued 27GB