Sony HT-SS2000 Operating Instructions - Page 28
When error codes appear, To rectify the error, When you select WARN CHK, Press, repeatedly to select
UPC - 027242712133
View all Sony HT-SS2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
2 Press V/v repeatedly to select the item. Then, press . Item Explanation RETRY Performs the Auto Calibration again. SAVE Saves the measurement results and exits the setting process. WARN CHK Displays warning concerning the measurement results. See "When you select "WARN CHK"" (page 28). PHASE Displays the phase of each speaker (in phase/out of phase). See "When you select "PHASE"" (page 29). DISTANCE Displays the measurement result for speaker distance. LEVEL Displays the measurement result for speaker level. EXIT Exits the setting process without saving the measurement results. 3 Save the measurement result. Select "SAVE" in step 2. The measurement results are saved. When error codes appear Try the remedies and perform the Auto Calibration again. Error code Cause and remedies ERROR 32 ERROR F 33 None of the speakers were detected. Make sure that the optimizer microphone is connected properly and perform the Auto Calibration again. If the optimizer microphone is connected properly but the error code appears, the optimizer microphone cable may be damaged or improperly connected. • None of the front speakers are connected or only one front speaker is connected. • The optimizer microphone is not connected. Error code Cause and remedies ERROR SR 33 Either the left or right surround speakers is not connected. ERROR SW 33 Sub woofer is not connected. Connect the sub woofer to the SUBWOOFER terminal. ERROR 33 Wrong speaker detection due to noise. Make sure the environment is quiet during Auto Calibration. To rectify the error 1 Record down the error code. 2 Press , "RETRY Y" appears on the display. 3 Rectify the error. For details, see "When error codes appear" above. 4 Press to perform Auto Calibration again. When you select "WARN CHK" If a warning on the measurement result is present, detailed information is displayed. Press to return to step 2 of "Confirming/saving the measurement results". Warning code Explanation WARN 40 The Auto Calibration has completed. However, the noise level is high. You may be able to perform the Auto Calibration properly if you try it again, even though the measurement cannot be performed in all environments. Try to perform the Auto Calibration in a quiet environment. WARN 41 The sound input from the optimizer microphone is out of the acceptable range. It is louder than the loudest sound that can be measured. Try to perform the Auto Calibration when the environment is quiet enough to allow proper measurement. WARN 42 The volume of the receiver is out of the acceptable range. Try to perform the Auto Calibration when the environment is quiet enough to allow proper measurement. 28GB