Sony HT-SS2000 Operating Instructions - Page 29

Getting Started Warning code Explanation WARN 43 The distance and position of a sub woofer cannot be detected. This may be caused by noise. Try to perform the Auto Calibration in a quiet environment. NO WARN There is no warning information. When you select "PHASE" You can check the phase of each speaker (in phase/out of phase). Press V/v repeatedly to select a speaker, then press to return to step 2 in "Confirming/saving the measurement results". Display xx* IN xx* OUT Explanation The speaker is in phase. The speaker is out of phase. The "+" and "-" terminals of the speaker may be connected the other way around. However, depending on the speakers, "xx* OUT" appears on the display even though the speakers are connected properly. This is because of the speakers' specifications. In this case, you can continue to use the receiver. * xx represent a speaker channel FL Front left FR Front right C Center SL Surround left SR Surround right SW Sub woofer Tip Depending on the position of the sub woofer, the measurement results for polarity may vary. However, there will be no problems even if you continue to use the receiver with that value. After you have finished Disconnect the optimizer microphone from the receiver. A. CAL menu parameters You can use the A. CAL menu to make settings for the Auto Calibration function to suit your preference. Select "8-A. CAL" in the amplifier menus. For details on adjusting the parameters, see "Navigating through menus" (page 34) and "Overview of the menus" (page 35). x AUTO CAL (Auto Calibration on/ off) • A.CAL NO The Auto Calibration function is turned off. • A.CAL YES The Auto Calibration function start. x CAL LOAD (Calibration load)* • LOAD YES Select this when you want to load the saved Auto Calibration result. • LOAD NO Select this when you do not want to load the saved Auto Calibration result. * You can select this parameter only when you have performed the Auto Calibration and saved the settings. 29GB