Sony HT-ST5000 Operating Instructions Large File - 11.43 MB - Page 49
Saving Power in Standby Mode, Sending the Remote Signal to the TV via the Main Unit
View all Sony HT-ST5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Using the Various Functions/Settings Saving Power in Standby Mode Check that you have made the following settings: - [Bluetooth Standby] is set to [Off] (page 55). - [Standby Through] is set to [Off] (page 56). - [Quick Start/Network Standby] is set to [Off] (page 57). - [Remote Start] is set to [Off] (page 58). Sending the Remote Signal to the TV via the Main Unit When the main unit obstructs the remote control sensor of the TV, the TV remote control may not work. In that case, enable the IR repeater function of the system. You can control the TV with the remote control of the TV by sending the remote signal from the rear of the main unit. 1 Press HOME. The home menu appears on the TV screen. 2 Select [Setup] from the home menu. The setup display appears on the TV screen. 3 Select [System Settings] - [IR- Repeater]. The [IR-Repeater] screen appears on the TV screen. 4 Select [On]. Notes • Be sure to check that the remote control of the TV cannot control the TV, and then set [IR-Repeater] to [On]. If it is set to [On] when the remote control can control the TV, appropriate operation may not be obtained because of the interference between the direct command from the remote control and the command via the main unit. • On some TVs, this function may not work correctly. In this case, place the main unit slightly further away from the TV. 49US