Sony HT-ST5000 Operating Instructions Large File - 11.43 MB - Page 56
System Settings], Bluetooth Codec - AAC], Wireless Playback Quality], OSD Language]
View all Sony HT-ST5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
[Bluetooth Codec - AAC] This function is only available when you set [Bluetooth Mode] to [Receiver] or [Transmitter]. [On]: Enable AAC codec. [Off]: Disable AAC codec. Notes • You can enjoy high-quality sound if AAC is enabled and your device supports AAC. • When connecting BLUETOOTHcompatible headphones, this setting cannot be changed. [Bluetooth Codec - LDAC] This function is only available when you set [Bluetooth Mode] to [Receiver] or [Transmitter]. [On]: Enable LDAC codec. [Off]: Disable LDAC codec. Notes • You can enjoy more high-quality sound if LDAC is enabled and your device supports LDAC. • When connecting BLUETOOTHcompatible headphones, this setting cannot be changed. [Wireless Playback Quality] You can set the transmission data rate of LDAC playback. This function is only available when you set [Bluetooth Mode] to [Transmitter] and [Bluetooth Codec - LDAC] to [On]. [Auto]: The data transfer rate is automatically changed depending on the environment. If audio playback is unstable in this mode, use the other three modes. [Sound Quality]: The highest bit rate is used. Sound is sent in a higher quality; however, audio playback sometimes may become unstable when the link quality is not good enough. [Standard]: The middle bit rate is used. It balances both sound quality and playback stability. [Connection]: Stability is prioritized. Sound quality may be reasonable and connection status will most likely be stable. If the connection is unstable, this setting is recommended. [System Settings] [OSD Language] You can select the language you want for the system on-screen display. [Wireless Subwoofer Connection] You can perform wireless connection of the subwoofer again. For details, see "Performing the Wireless Connection of the Subwoofer (SECURE LINK)" (page 45). [IR-Repeater] [On]: Remote signals for the TV are sent from the rear of the main unit (page 49). [Off]: Turns off the function. For details, see "Sending the Remote Signal to the TV via the Main Unit" (page 49). [HDMI Settings] • [Control for HDMI] (page 50) [On]: The Control for HDMI function is enabled. Devices connected with an HDMI cable can control each other. [Off]: Off • [Standby Linked to TV] (page 50) This function is available when you set [Control for HDMI] to [On]. [Auto]: If the input of the system is [TV], [HDMI1], [HDMI2], or [HDMI3], the system turns off automatically when you turn off the TV. [On]: The system turns off automatically when you turn off the TV regardless of the input. [Off]: The system does not turn off when you turn off the TV. 56US